Bar30 High-Resolution 300m Depth/Pressure Sensor

Bar30 High-Resolution 300m Depth/Pressure SensorThis pressure sensor can measure up to 30 Bar (300m depth) with a depth resolution of 2mm. It is waterproof and ready to install. The anodized aluminum body was designed around the cable penetrator design and is compatible with all of the watertight enclosures. The sensor communicates over I2C. It operates on 3. 3V I2C voltage but can accept power input up to 5. 5V. It comes standard with a JST GH connector that is compatible with most flight

and an open-source software interface that makes it a capable tool for ROV navigation and underwater acoustic imaging

but this connector can be used to retrofit older tethers

All of the holes are compatible with all of our M10 penetrators

This foam can be machined

1 x M10 Nut

24 in 6 mm Weight 0

smart over-temperature compensation for maximum light output and safety in air

Weight in Air

Using the interrogate/response model of a traditional USBL system

1 x Flange (based on selection)

battery status

3 x 200mm JST-GH to JST-GH twisted pair cable