3M EC Glue Gun Heater Repair Kit Application|Woodworking & Furniture

3M EC Glue Gun Heater Repair Kit Application|Woodworking & FurnitureIf your 3M EC glue gun will not heat it could be a few different problems to check and see if the heater is what needs to be replaced. Turn the EC glue gun power switch on and check the electrical continuity of the heater TCO switch assembly. Use an ohmeter and measure across the terminals numbered 3 4 on the top terminal block labeled TB2. The measured value should be between 40 50 ohms. If the measured value is not in that range then replace the

000 cps 3750 -65 to+250° F <18 Sec/8 Hours Type II

This heat gun is extremely powerful and offers about 30% more air than conventional tools

The 3M 9913 works with all of the 3M hot glue guns with the exception of the 3M Polygun AE

The Power Adhesives PA6039 filter and regulator gauge is used with any of their pneumatic glue guns including the Tec 6100

Carpet Repair

and substrates with moderate oil contamination

The PG II is also available with Speedloader Magazine to hold up to 12 sticks for convenient dispensing

About the 3M EPX Gold Static Mixer for 200ml and 400ml Cartridges

HANDLING STRENGTH: 30 MINUTES

Another benefit is the Tec4500B is pneumatic making it easy to use without worker fatigue setting in quickly

and encapsulating delicate electronic components

and other substrates in general industrial settings