Rethreading Tap Extension Sleeve For Taps with 3.4mm Square DIN 377 Replacement Jockey Handles

Rethreading Tap Extension Sleeve For Taps with 3.4mm Square DIN 377 Replacement Jockey HandlesProfessional tap extension for commercial or occasional use 3. 4 mm Tap extension for square drive hand and machine taps threading tools Allows taps to be used in an awkward hard to reach deep set area Tap extension for taps with 3. 4mm square drive So suitable for taps with a 3. 4mm square end that can be pushed into the sleeve to create the extension when required necessary Manufactured from DIN 377 steel for maximum strength and durability Fully

This listing is for 1 rubber sanding block

50mm Twist-Button backing pad

DIAL GAUGE

In a rural area: Choose any colour

This listing is for a set of three pullers 3"

Hundreds of uses around the home and workshop

• 1 x 12" internal circlip pliers (straight)

W85mm and H135mm

• BURST PRESURE - 1500 PSI / 100 BAR

-Total length of the cutters 8" / 200mm

Suitable for the removal of piston rings on most cars / vans / motorbikes / trucks etc

This attachment is made up of approximately 19 needles which chip away at the surface