WHITES FORK CAP SOCKET mini

WHITES FORK CAP SOCKET miniThe Whies Fork Cap Socket is used for removal and installation of the fork cap nut (1 3 8 hex) on most big twin and sportster models. Constructed with an o ring insert design that allows you to remove install the fork cap without the risk of damaging the fork cap. An inbuilt 1 2 square socket drive enables the use of a torque wrench for tightening to the manufacturers recommended specification eliminating the risk of under or over tightening and

Number of pins: 8

The inner liner is washable breathable and has moisture-wicking anti-odour fabric

Hydration bladder pocket with tube routing

Take note of the wire colours of the original stator wires and disconnect them from the wiring loom

Long shaft grants access to hard to reach places

Stator Wire length: 210 mm

Viscosity -25°C: 4280mPa

Brand New 22 x 11 - 10 inch Rear Wheel Rim + Tyre Tire 200cc 250cc Quad Dirt Bike ATV Dune Buggy Go Kart

Each filter piece has pleated media which creates a large surface area that provides high airflow and great dirt holding capacity for extreme conditions

Length: 76 mm

The HFP-342DI is a true direct install

No need for water—simply spray