MSD - MSD Crank Trigger Pickup Sensor - Hall Effect

MSD - MSD Crank Trigger Pickup Sensor - Hall EffectPN 8278 is the replacement Hall Effect Sensor for flying magnet crank trigger setups using a 3 4 16" threaded. This sensor is a Hall Effect sensor, meaning it outputs a square wave signal, which is ideal for use with most Electronic Fuel Injection Systems. This sensor is to only be used with a trigger wheel with "flying magnets". It does not detect a ferrous steel target.

The Circle Track HEI module is built specifically to produce the spark energy and performance demanded for racers required to keep a "Stock Appearing" module for rules purposes

Timing Chain Set - Performer-Link - Double Roller - Keyway Adjustable - Cast Iron / Billet Steel - Big Block Chevy - Kit

625 in H x 3 in D - Driver Side Inlet - Driver Side Outlet - Aluminum - Natural - Each

50 Female Inlet - 12 mm x 1

15 lb - SFI 1

Cylinder Head - Performer RPM E-TEC 170 - Assembled - 1

Rocker Arm Nut - 3/8-24 in Thread - Steel - Black Oxide - Stud Girdle - Chevy V8 - Set of 16

Valve Cover Fastener - Mini Nut - 1/4-20 in Thread - 3

Timing Cover - 1-Piece - Seal Included - Chevrolet / Bowtie Logo - Steel - Orange Paint - Small Block Chevy - Each

Crate Engine - Base Dressed Engine - EFI - 302 Cubic Inch - 361 HP - Small Black Ford - Each

Coil Spring - Conventional - 5 in OD - 11 in Length - 375 lb/in Spring Rate - Rear - Steel - Silver Powder Coat - Each

25 in Long - 6 in Drop - 7500 lb Capacity - Steel - Black Powder Coat - 1 in Shank Hitch Ball - Each