Bando TL18L100 TL Timing Belt Pulley (1008) AC MOTORS - NEMABando TL18L100 The type of pulley used on a Synchro Link drive depends on a number of factors, including but not limited to, space available, ratios, center distances, horsepower being transmitted, speeds and user preference of mounting systems (i. e. QD, TL or Minimum Plain Bore). With Synchro Link Drives, as with gear or chain drives, circular pitch (usually referred to as pitch) is a fundamental consideration. On the belt, pitch is the distance
Bando - TL1210 1 1/8 TL® bushings are preferred where mounting space is at a premium
Motor RotationCWLE
1 RATING 40C AMB-CONT CC 010A DE 6312 ENCL TEFC BLANK 20:1 CT & VT
3327 CFM @ 0
US Motors9641
Bando - 100-S2M-396UK Unique modified curvilinear tooth form enables the STS belt to transmit greater loads than like-sized drives having the standard high torque tooth profile
60 A Rated torque 0
offering low vibration levels
Bando - SD 1 7/16 The original sheave and pulley mounting system developed to facilitate installation and replacement of components
5 POLES 4 NUMBER SPEEDS 1 RPM 1750 RPM 2 1750 RPM 3 1735 RPM 4 1435 RPM 5 1435 HERTZ 60 HERTZ 2 50 VOLTS PRIMARY 208-230/460 VOLTS 460 VOLTS 2 230 VOLTS 3 208 VOLTS 4 380 VOLTS 5 190 FRME 145 SHAFT CODE T MOUNTING HORZ-FOOTED ASSEMBLY POSITION F1 MOTOR TYPE UTE OPPOSITE END BEARING 6203-2RS SHAFT END BEARING 6205-2RS AMBIENT 40 ROTATION DUAL SERVICE FACTOR 1
4x(Code J) No load current 44
875 IN Shaft Ground Indicator No Shaft Grounding Shaft Rotation Reversible Speed 1770 rpm Speed Code Single Speed Motor Standards NEMA Starting Method Direct on line Thermal Device - Bearing None Thermal Device - Winding Normally Closed Thermostat Vibration Sensor Indicator No Vibration Sensor Winding Thermal 1 None Winding Thermal 2 None XP Temp Code T3C Drawings
