PlatinumRC iSDT N8 & N16 AAA & AA Battery Charger Stand Holder PREORDER

PlatinumRC iSDT N8 & N16 AAA & AA Battery Charger Stand Holder PREORDERThis is a 3D Printed stand for your iSDT Limeta N8 & N16 charger. The stand clips onto either side of the charger to tilt it up at a 45 angle to make it easier to see your screen and to insert and remove batteries. **CREDIT TO DESIGNER** by Fusselflitzer is licensed under the Creative Commons Attribution license https: creativecommons. org licenses by 4. 0 PLEASE READ BELOW BEFORE PURCHASE: 1 This is a 3D print, so there may be some very slight

Earth gripping tread design

Infrection

035") Polycarbonate

the problem was all of available spec tires are ether too hard for Spring and Fall-Winter season which makes racers ice skating

Belted Short Course Tires with Exceptional Off-Road Control

improving motor efficiency

with low internal resistance

They’re also lighter than stock by 4 grams each (or 8 grams in total for both rear A-arms)

22 Adjusting Gear Mesh)

Provides added slipper cooling via the extra heat sink fins that also spins as fan blades as the motor turns for increased air flow over the slipper plate therefore helping reduce heat glazing of the slipper pads which results in melted pads

The tire carcass is marked with a special texture which helps the driver with orientation during mounting

Maximum Range: 100m (Except the MINIT system) (Optimum condition)