Adafruit 16-Channel 12-bit PWM/Servo Shield - I2C interface GPS

Adafruit 16-Channel 12-bit PWM/Servo Shield - I2C interface GPSThis handy PWM and Servo driver shield will allow you to easily create multiple moving parts in your next project. It's just like the popular PWM Servo Breakout but now Arduino ready and works with any Arduino that uses shields: Uno, Leo, Mega, or ADK. This chip will allow you to control 16 free running PWM outputs using only two I2C pin. As well, it will allow stacking of up 62 shields to control up to 992 PWM outputs. Because I2C is a shared bus you

but also means that the chip only uses a single pin for input and a single pin for output

Volume can be controlled with the onboard thumbwheel potentiometer

all with sound

The address can be changed to one of four options (see the datasheet table 5) so you can have up to 4 ADS1115's connected on a single 2-wire I2C bus for 16 single ended inputs

Works with all Feathers except for the ESP8266 Huzzah Feather (the hardware UART is taken)

875 times as many but that's within a margin of error)

12V and -12V) each with their own replaceable 5A fuse

If you try to control these with a plain 'RGB' NeoPixel library

Since this is our new favoritest SPI-protocol WiFi module we've decided to make a little breakout for it

This version of the popular BlueSMiRF uses the RN-42 module which has a bit less range than the RN-41 module used in the BlueSMiRF Gold

SRAM and performance of the earlier nRF51-based Bluefruit modules

If you aren't so concerned about streaming a video